The commands remain in effect throughout the communications session, unless the software sends other commands to override them.
The software determines which commands should be included in the initialization string, based on the device you select during installation. If your fax software gives you the option of selecting Class 1 or Class 2 fax drivers, select Class 1.Īn initialization string is a group of AT command settings that is sent to the modem as soon as you start up the software. All communications between the computer and the faxmodem take place at this higher speed, independent of the modem-to-modem speed.
In the dialing directory, set all entries to the highest possible baud rate, if your software and serial port support these speeds (do not go over 115,200 bps). However, you should be aware of the following items: If you are asked to select the “modem type” from a menu, and you don’t see this modem listed by name, select the most descriptive name such as V.92 modem, 56K modem, or generic Class 1 Modem. Most programs have default settings that are correct for use with this modem, and there is no need to change them. In setting up some older software programs, you may be asked to enter certain information. If you run into configuration difficulties with your communication software, it may be helpful to read the following section.
0 kommentar(er)
